Small Multifunctional Snow Blower Notes

Small multifunctional snow removal machine in operation also need to pay attention to some matters, the specific matters are as follows.

    1, check whether there are loose parts or oil leaks, open the snowplow before repair.

    2, first open the snowplow, make it idle for 2 minutes, so that the engine warm up.

    3、Prohibit the implementation of any maintenance in the process of using the snowplow.

    4、Please keep your body away from dangerous parts and make sure the snow raising opening is clear.

    5、When crossing the road or walking on the sidewalk, please pay attention to the potential danger or car accident.

    6、Shut down the snowplow immediately when there is a strange noise.

    7、When cleaning the surface of the snow plow and the snow raising mouth, please turn off the snow plow.

    8、Please make sure the rotating parts are completely stopped before inspection or maintenance.

    9, snow plow brush and machine forward direction slightly angle, the angle can be adjusted, the machine since the process of walking brush forward rotation, the snow will be cleared to the side.

    10, wide road or square clearing, you can start from the middle of the operation, and gradually the snow 'drive' to the side of the road.

    11, small multifunctional snow removal machine with a single operator, flexible in use, will not crush the road, will not bump the roadside vehicles and other advantages, unlike large equipment requires a driver's license or even a special operating permit, and in narrow spaces when easy to bump the surrounding vehicles and pedestrians, etc.

    12、Before the engine, disconnect all the control rods. Feet must be away from the machine, and no one can stand in the work area.

    13, in the vicinity, especially children or pets, do not use the small multifunctional snow removal machine equipment. The operator must not allow children or untrained people to use the machine.

    14、Do not use the machine without the control equipment and safety equipment installed.

    15、Do not lift or carry the machine while the engine is working.

    16、Do not store the machine in a closed space with fuel in the tank. The exhausted air is dangerous.

    17、Do not change the parameters of the engine of the small multifunctional snow removal machine. If the engine runs too fast, the risk of accidents will increase.

    18、Do not open the fuel tank cover or refuel the engine without cooling it.

    19、Do not open the fuel tank cover or refueling when the engine is not cooled.

    20, do not start the engine in a closed environment, the exhaust contains toxic carbon monoxide gas.

    21、If there is fuel spilled out, do not start the engine again in the spilled area.

    22、The work needs to ensure that there are no large stones, obvious stones, etc. in the heaven and earth. Ensure that the equipment will not cause damage to the gears and blades of the machinery due to rocks.